March 4, 2025
Configuration Checks Ensure WAN interfaces used for Internet, Tunnel, or SaaS breakout have ICMP failover configured with reachable public IP addresses. Gateway IPs for Internet and […]
March 4, 2025
1. Verify WAN to LAN Forwarding: Check if WAN to LAN forwarding is enabled on the Router → Routes page. Issue: If disabled, traffic forwarding across […]
March 4, 2025
1. Check if the DNS Unbound service is running: systemctl status unbound Expected Scenario: The service should run without any failures. 2. Ensure the LAN interface […]
March 4, 2025
Make sure all the discovery failed LAN PC are connected via switch instead of direct cable connected to CPE. Directly cable connected LAN PC to CPE […]
March 4, 2025
Follow these steps to debug EC event issues on your AmZetta zWAN device: Step 1: Enable Debugging Create a debug file by running the following command: […]
March 4, 2025
1. Check LAN PC Connectivity Verify the cabling between the LAN PC, CPE, and switch. Check the NIC status on both the client and server. 2. […]
February 27, 2025
Setting Up IPv6 on AmZetta zWAN Overview IPv6 is the latest version of the Internet Protocol, designed to address the limitations of IPv4. It introduces a […]
February 19, 2025
DNS Stub Zone A stub zone in zWAN CPE can be configured to point to an authoritative server for references to a specific zone. This can […]
February 19, 2025
DNS Auth Zone (Zone Transfer) Overview The zWAN CPE supports authoritative DNS zones and allows for zone transfers. Zone transfers ensure fault tolerance by synchronizing the […]