How Can We Help?

< All Topics
You are here:
Print

Load Balancer

Overview

What is Load Balancing?

How is Load Balancing

Load balancing leverages traffic steering technology in order to balance traffic going in and out of an edge controller. Traffic steering is used when the router is configured with multiple internet connections or tunnels for reasons such as balancing outgoing LAN traffic, maintaining network redundancy and faults for one or multiple lines. The LAN traffic is distributed by using a weighted round-robin policy over the multiple internet gateways or tunnels. In other words it’s connection based load balancing. Traffic can also be steered through a single interface. The detection of traffic is done by the flow classifier module, which offers multiple ways of detecting traffic like 5-tuple, nDPI, L7, etc..

Functionality

It supports 2 modes of traffic

  1. Branch
  2. Internet Breakout

In Branch mode, gateways can be grouped based on the LAN network to form a separate load balancing group In Internet breakout mode, any traffic which does not belong to the branches are forwarded to the default internet gateways

Each load balancing group can be configured in 2 modes

  1. Load balancing and Failover
  2. Failover

Failover monitoring is done by either monitoring the liveliness of the physical interface or the gateway IP address or manually configured Failover IPs to verify the absence of routing issues. The reliability of the latter can be influenced by the network level congestion and their response times. So proper calibration is required for the same. There are multiple parameters which are used to avoid transient failure detection like

  1. Number of probes before marking DOWN
  2. Number of probes before marking UP
  3. Pause before New Cycle
  4. Reply Timeout

Configuration Parameters

Add a Load Balancer gateway

Edit a Load Balancer gateway

View the Load Balancer gateways

Configure the Load Balancer

Use Cases

To classify and steer traffic over dedicated links.

Known Limitations

  • Only 99 Load balancer Gateways can be created per ZWAN controller
Was this article helpful?
0 out Of 5 Stars
5 Stars 0%
4 Stars 0%
3 Stars 0%
2 Stars 0%
1 Stars 0%
How can we improve this article?
Please submit the reason for your vote so that we can improve the article.
Table of Contents
Top